Add Bail
Position the halo and add a custom bail for pendant attachment.
Last updated
Position the halo and add a custom bail for pendant attachment.
Last updated
Select the diamond and halo. Use the gumball
Click the green arrow, type -6 and press enter.
Click the blue arrow, type 1.4, and press enter.
In the Components (1) tab, select the Bail command (2).
Click Edit (1):
Open the Asset selector panel (1). Select Asset 007 (2) and edit the profile (3), keeping only three left-side points (4).
Set the Height to 1.5 millimeters.
In the bottom profile tab, select the same asset for the profile (007).
Set the Width to 1.8 millimeters.
Configure the airgap settings:
Bottom Diameter: 0.6 mm
Internal Distance: 5 mm
Starting on top to 30%
Starting on bottom to 25%
Curve tension to 40%.
Enable the O-Ring, set Thickness to 0.9 mm, and Diameter to 1.5 mm. Confirm changes by clicking “Confirm Changes” in the top-right corner.
Next Lesson
In the next lesson, we will create a beautiful scene, to get the most out of our model.
