Curve

Below is a list of commands tailored for the creation and management of curves in your project.

Curve

Draw a curve from control point locations.

Control Points

Fit a curve through picked locations.

Control Points From Polyline

Builds a curve using the control points of a polyline

Handle Curve

Draw chained Bézier curves with editing handles.

Sketch

Drag the mouse to draw a curve.

Sketch On Surface

Drag the mouse to draw a curve on a selected surface.

Sketch On Mesh

Drag the mouse to draw a curve on a selected mesh.

Conic

The Conic command draws a conic section curve based on a start, end, and apex point.

Conic: Tangent At Start

Lets you select a curve for the conic curve to be tangent to for the start or end of the conic.

Parabola From 3 Points

Draw a parabolic curve through three picked points.

Parabola By Focus

Draw a parabolic curve from focus and vertex or endpoint.

Hyperbola

The Hyperbola command draws a hyperbolic curve.

Catenary

Creates a curve that a hanging chain or cable assumes under its own weight when supported only at its ends.